This issue was so frustrating for me when using the Creality CR-10s Pro, so i just converted it to a Direct Drive System and that fixed my issues for good.Īll the mentioned issues are not present in a Direct Drive configuration, like on the Artillery Genius. They fail constantly and getting quality replacement is close to impossible. The most frustrating issue in a Bowden setup is the use of bad quality bowden fittings. It’s like painting a picture: try to paint with a 1m long brush, grabbing the rear end of the handle which is made from rubber Any 3D printer in 2020 should use this feature to improve print quality. Besides that, retraction values are a lot higher compared to a Direct Drive.Īnother important feature that it’s hard to tweak and use on a bowden setup is Linear Advance. This is a true statement, but with a Bowden setup, it’s harder to control oozing and stringing. Because the entire hotend assembly is lighter, you should get improved printing performance. Some people swear that this system allows you to print faster. The Creality Ender 3 V2 uses the traditional bowden setup present in most of Creality’s machines. It’s not as good as an original Titan extruder, but it’s a lot better compared with Creality’s offering. In my opinion, the winner here is the Genius extruder. The Creality plastic extruder used on the Ender 3 V2 does not have this.
DRIVE GENIUS 2 REVIEW MANUAL
The Titan Extruder clone used by the Genius also has manual tensioning of the spring allowing fine tweaks in the gear pressure over the filament. This part could be also 3D printed in PETG / ABS or order one in Aluminum to fix the issue for good. While there are some issues with the stock configuration (extruder lever might break), you get a spare in the package. On the other hand, the Artillery Genius comes with a Titan Extruder clone, in a direct drive configuration.
DRIVE GENIUS 2 REVIEW UPGRADE
Some users upgrade to a metal extruder to fix this issue, or even better, a dual-gear extruder. Besides that, the lever tension on the filament is low, and the filament could have extrusion issues. Because of the positioning, the filament rubs on the plastic and cuts trough it damaging the lever. The Ender 3 V2 comes with the same low quality plastic extruder we got in the past.
11 Ender 3 V2 vs Artillery Genius – Conclusions Ender 3 V2 Creality Extruder vs Artillery Genius Titan Clone
0 kommentar(er)
